Please Choose:


Agir Ratatosk Side Mount Wing


Agir sidemount equipment is neat and clean is all about simplicity.  Ratatosk is basic, hardwearing equipment but not without finesse.

The AGIR Ratatosk is a single bladder wing.  The outer shell is made of 1000 denier cordura (rugged ballistic nylon).  Its compartmented inner bladder is manufactured from ultrasonically welded 400 denier cordura - a highly resistant material.  The inflator has a reinforced mounting hole with an 18” long corrugated hose.  The low pressure hose is 200mm / 8” long. 300mm / 12” is available as an option for regulators without a so called 5th port.

Both the elbow and inflator assembly can be adjusted for optimum positioning. The overpressure relief- / dump valve (OPRV) is at the bottom center of the wing and can be reached with either hand.  The OPRV is equipped with a 150mm / 6” long, 3 mm thick nylon cord and is easy to use.  On each side of the valve is a loop and along with them, also two on each side of the wing. Bungee cord run through the loops and the bungee ends, when connected, will strap the wing to your body and keep it close when adjusting buoyancy during diving.  You may pull it tighter or looser, whichever you prefer. The loops on each side of the OPRV helps to keep the bottom end of the wing tight to your body and these bungee cords run the same way as the crutch strap.  This strapping creates a controlled streamlining without restraining the wing in terms of lift.  In other words, you keep the wing in place and reduce the risk of damage without losing any capacity.  You may also attach the wing to the spinal webbing using the flaps with velcro.  Just below these is a 280cm/11¨ zipper that allows easy access to the inner bladder.  Two grommets for drain are placed in the bottom of the wing.

The Ratatosk wings threads into the harness as shown here

We have the Black and Camo versions available.  please specify choice with your order.

  • Manufactured by: Agir-Brokk

  • Your IP Address is:
    Copyright © 2019